Loading...
2 results
Search Results
Now showing 1 - 2 of 2
- Effect of Polymer Dissolution Temperature and Conditioning Time on the Morphological and Physicochemical Characteristics of Poly(Vinylidene Fluoride) Membranes Prepared by Non-Solvent Induced Phase SeparationPublication . Cardoso, V. F.; Botelho, Gabriela; Morão, António; Nunes-Pereira, João; Lanceros-Mendez, SenentxuThis work reports on the production of poly(vinylidene fluoride) (PVDF) membranes by non-solvent induced phase separation (NIPS) using N,N-dimethylformamide (DMF) as solvent and water as non-solvent. The influence of the processing conditions in the morphology, surface characteristics, structure, thermal and mechanical properties were evaluated for polymer dissolution temperatures between 25 and 150 C and conditioning time between 0 and 10 min. Finger-like pore morphology was obtained for all membranes and increasing the polymer dissolution temperature led to an increase in the average pore size ( 0.9 and 2.1 m), porosity ( 50 to 90%) and water contact angle (up to 80 ), in turn decreasing the PVDF content ( 67 to 20%) with the degree of crystallinity remaining approximately constant ( 56%). The conditioning time did not significantly affect the polymer properties studied. Thus, the control of NIPS parameters proved to be suitable for tailoring PVDF membrane properties.
- Mesoporous poly(vinylidene fluoride-co-trifluoroethylene) membranes for lithium-ion battery separatorsPublication . Costa, C. M.; Kundu, Manab; Dias, J. C.; Nunes-Pereira, João; Botelho, Gabriela; Silva, M. M.; Lanceros-Mendez, SenentxuMesoporous separator membranes based on poly(vinylidene fluoride-co-trifluoroethylene), PVDF-TrFE, were prepared through the removal of ZnO nanoparticles from the polymer matrix composite. Different filler concentrations were used, and the evaluation of the morphology, mechanical properties, uptake and ionic conductivity of the membranes were demonstrated that they depend on initial ZnO content in the composite. On the other hand, the vibration peaks characteristics of PVDF-TrFE and the thermal properties are independent on initial filler content. The membrane with the best ionic conductivity, 1.6 mS/cm, is the one prepared after 70 wt.% ZnO removal. The separator membranes were assembled in Li/C-LiFePO4 half-cells exhibiting good rate capability and cycling performance, the best battery performance being obtained for the PVDF-TrFE after 70 wt.% ZnO removal. The good performance of the developed separators was also demonstrated in full battery cells. Thus, a way to tailor membrane mesoporosity is presented and it is shown that the obtained membranes represent suitable separators for lithium-ion battery applications.