Microelectromechanical Systems Research Unit

Funder

Organizational Unit

Publications

Evaluation of the Physicochemical Properties and Active Response of Piezoelectric Poly(vinylidene fluoride-co-trifluoroethylene) as a Function of Its Microstructure

Publication . Gonçalves, R.; Cardoso, V. F.; Pereira, Nelson; Oliveira, Juliana; Nunes-Pereira, João; Costa, C. M.; Lanceros-Mendez, Senentxu

Poly(vinylidene fluoride-trifluoroethylene), P(VDF-TrFE), microstructures have been produced using different solvents, including green ones, by different techniques, such as solvent casting, screen-printing, replica molding, electrospray, and electrospinning. The obtained microstructures span from simple porous and dense films to spheres, fibers, and patterned three-dimensional architectures, with no significant variation in their physicochemical and electrical properties. The simplicity, low cost, and reproducibility of the processing techniques allied to their versatility to adapt to other materials to produce controlled and tailored microstructures with specific properties demonstrate their potential in a wide range of technological applications, including biomedical, energy storage, sensors and actuators, and filtration.

2018Journal article

Restricted access

Mesoporous poly(vinylidene fluoride-co-trifluoroethylene) membranes for lithium-ion battery separators

Publication . Costa, C. M.; Kundu, Manab; Dias, J. C.; Nunes-Pereira, João; Botelho, Gabriela; Silva, M. M.; Lanceros-Mendez, Senentxu

Mesoporous separator membranes based on poly(vinylidene fluoride-co-trifluoroethylene), PVDF-TrFE, were prepared through the removal of ZnO nanoparticles from the polymer matrix composite. Different filler concentrations were used, and the evaluation of the morphology, mechanical properties, uptake and ionic conductivity of the membranes were demonstrated that they depend on initial ZnO content in the composite. On the other hand, the vibration peaks characteristics of PVDF-TrFE and the thermal properties are independent on initial filler content. The membrane with the best ionic conductivity, 1.6 mS/cm, is the one prepared after 70 wt.% ZnO removal. The separator membranes were assembled in Li/C-LiFePO4 half-cells exhibiting good rate capability and cycling performance, the best battery performance being obtained for the PVDF-TrFE after 70 wt.% ZnO removal. The good performance of the developed separators was also demonstrated in full battery cells. Thus, a way to tailor membrane mesoporosity is presented and it is shown that the obtained membranes represent suitable separators for lithium-ion battery applications.

2019Journal article

Restricted access